Hello Slimat,

Not possible to access DASH2 PRO menu whilst vehicle in motion, done to promote safe driving. Button functions can be changed in the DASH2 PRO configuration utility in User Control Inputs. For example, change Set / Select button function to Add Marker.

Hello,

Please send a copy of your DASH2 PRO configuration file to the following address, I will investigate the alarm issue, check on the oil pressure reading in PSI and setup battery voltage.

daniel AT race - technology DOT com

Thanks for the info, the data logger will need to be logging in order to record lap timing information. So you will still need a switch (latching switch) connected to the DL1 PRO in order for the units to identify when the pit lane has been entered & exited. Send a copy of your DL1 PRO & DASH4PRO un...

You need to pair the DASH4PRO with one of our data loggers for timed equation functionality, do you have one (if yes, which model)?

Thanks for the car info, I'm not sure why the RPM from the OBDII port is reading as it is. However the best thing to do is take the RPM from a fuel injector instead. The data transmit over the OBDII port is very slow, it's not fast enough for RPM. Taking the signal from a fuel injector will give you...

It seems odd that an electronic device would cause such an issue, could you possibly disconnect the DASH2 and see if the running-on issue persists? Might have just been a coincidence that the issue occurred whilst fitting the dash, thanks.

Haven't seen that issue before, which vehicle (make, model & year) is the system installed on please?

Hello Chris - Yes that's correct the OMEX 600 firmware must be 0.70D. For ECU communication you will need either the DL1 CLUB ECU license or our ECU Interface, do you know if you have either? If you have an invoice to hand, email it to daniel AT race - technology dot com so I can see exactly what eq...

Mick email your DASH2 configuration to daniel AT race - technology DOT com and I will make the changes you require.

You can minus the 100 after the multiplier by typing '-100' in the lower box, however I don't think you'll need to do that. Try the 0.145 multiplier on it's own firstly then subtract the 100 if still reading absolute pressure.

Sorry Mick misread the post. For the DASH2 standard running latest software you can enter the equation in either the Other Data Sources section or the ECU Interface section, depending on where the channel has been enabled. Set the Boost Pressure units to Custom then multiply by 0.145, I've attached ...

Hello mick - you can enter equations in the Variable Source section on the DASH2 PRO config utility. Read back the current config from the dash > open Variable Source section > scroll down to the General variable 1 and select the 'calculate from a combination of inputs using equation' box > in the n...

Hi - it's difficult to say without the unit in front of me. Would you be able to post the dash to us for inspection? If yes, please email daniel AT race - technology DOT com and I'll provide a returns number.

Thank you

Hi Andy - Yes, download the V10 (RACING) software from our website, open the File Manager. There you can search for .LAP files and download them to your PC / memory card.

Hi Mark - We can try a force reflash, do you have any buttons currently connected to the DASH2? We need to use the UP button in order to access the force reflash mode.