Right I’m sorted now! Dash is now working
A mixture of speaking to Lorne at RT who checked the config over and double checking my wiring etc..
Ecu and dash 2 now working fine
Search found 4 matches
- Thu Aug 23, 2018 8:20 pm
- Forum: General software support
- Topic: LINK G4+ ,ECU CAN ADAPTOR, DASH 2
- Replies: 11
- Views: 32340
- Fri Aug 17, 2018 7:03 pm
- Forum: General software support
- Topic: Link G4+ extreme ecu and Dash 2 not receiving CAN
- Replies: 1
- Views: 11395
Link G4+ extreme ecu and Dash 2 not receiving CAN
So to save thread crapping other peoples threads ad problems I’ve started my own.. So the issue is I can’t read read CAN information from my ecu on my Dash 2 display My set up is: Link G4+ extreme ecu Link CANF connector RT CAN interface lead pre programmed with link g4+ ecu Dash 2 display I install...
- Fri Aug 17, 2018 6:26 pm
- Forum: General software support
- Topic: LINK G4+ ,ECU CAN ADAPTOR, DASH 2
- Replies: 11
- Views: 32340
Re: LINK G4+ ,ECU CAN ADAPTOR, DASH 2
That is a bit strange it’s going blank and doing that. Have you thought about deleting the RT download and reinstalling dave?
- Fri Aug 17, 2018 5:29 pm
- Forum: General software support
- Topic: LINK G4+ ,ECU CAN ADAPTOR, DASH 2
- Replies: 11
- Views: 32340
Re: LINK G4+ ,ECU CAN ADAPTOR, DASH 2
I’m am doing the same at the minute and having similar issues! I have Link G4+ extreme ecu Link CANF connector RT CAN interface lead pre programmed with link g4+ ecu Dash 2 display I installed the CAN interface lead by commenting the terminator connector to 12+ and ground in the loom, then put a Lin...