faraday wrote::shock: What do you expect

Peace in our time and working features... so no chance then

I have the same issue also

Hi, Have you set up your start end end run markers? As it is not a circuit, the track marker setup functionality is different: 1. Load up your RUN file 2. Using the MAP display and an XY graph showing RPM or Speed, work out where you started your run. 3. Hit the Add Track Marker button as usual and ...

Just purchased Serial ECU Interface to connect Motec M4e to DL1 MK1 & Dash 2. Reflashed Dash 2 to show Version 9.0.0, DL1 to Ver 9.5. Set Motec Telemetry Baud rate to 9600 and data set 5 as instructed in ECU interface manual. I can't get any ECU data to show up on dash 2 or log using DL1. Does ...

Simple. Perhaps someone else can join the discussion and toss 'round ideas about how the DL1 might be used. I have been using my DL1 in conjunction with the ECU interface (Motec) for engine tuning with good results. One of the issues I faced with using the Motec ECU (M48) is the small internal buff...

Makes total sense thanks.

Hi, I have updated my firmware to 9-1 and am running the Analysis Software at 7.2.24 using a Dl-1 Mk1. When I change the analysis options to enable raw GPS in analysis options and select Use pre-processed 5hz/10hz and reprocess the data I get the error message "You selected to use Raw GPS data ...

Old style DL1 (2 connectors), current firmware is V2.1

Thanks

Andy

Getting a lot of "electronic overlay timed out messages" when using the map overlay feature - very impressive when working though! Yes, I am getting that and "There was an error in the loading procedure" pretty much everywhere, but as you say, it looks like a good improvement wh...

Glad to see that the standards of support and feedback have not changed with the shiny new web site

The new site no longer seems to have the software revision list. How can I tell when there has been a version change and I need to get the latest version?

Thanks

The new download section no longer seems to show the actual minor version number of the software or the revision list. Does it still exist somewhere? If not can it be put back please?

... tell what the current version of the software is from the new web site? Does the revision list still exist somewhere?

Thanks

... tell what the current version of the software is from the new web site? Does the revision list still exist somewhere?

Thanks

I did the same a couple of years ago and kept everything except the speed sensor. The other sensors worked fine.

Andy