Here's a pic of the original installation...... https://www.facebook.com/photo.php?fbid=435230626527056&set=pb.227986643918123.-2207520000.1369856724.&type=3&theater The wheel is bolted between the driveshaft and gearbox drive outlet. The sensor on the left is for the Dash2 and the one o...

Quick update..... reflash problems sorted. I bought a new USB / Serial adapter with a verified Prolific chipset, changed the latency settings in device manager down from 16 to 4 and hey-presto, all good! Lesson learned, no more cheapo cables!!

Hi folks, thanks for the replies. After a chat with Race Tech, I decided that rather than adding more "kit" to work around the problem, I've given my trigger wheel some dentistry, courtesy of my friend Mr Dremel! So now my 36 tooth trigger wheel is down to 12, which allows me to drop down ...

I think your out by 2 decimal places as it should be cm not meters 1609/206.7 x 36 = 280.23 HTH Hi Striker.... so are you saying the manual is wrong then?? Copy/paste directly from my Dash2 manual states: "measure on the ground the distance travelled during one complete wheel rotation in metre...

Thanks for the reply.... more money and extra bits of kit required then I best go and disconnect the hall sender now, or half a dozen passes of the Bruntingthope runway will put 500 miles on the car, LOL!

I have this same problem...... Either OP can you share the solution, or can RT support help me with the divider program pls? My situation is I need to input 28,023 pulses per mile (36 tooth trigger wheel with 2.067m rolling circumference tyres). I have posted a new post in the general forum, but tho...

As the title says, how do I configure the Dash2 to accept 28,023 pulse per mile for the speedo? The dash's internal config stops at 12,000... .... I did see another (old) thread discussing this and it looked like there was a secret solution, but this wasn't discussed on the forum. Does anyone know w...

Nightmares.... I noticed recently my Dash2 was taking multiple attempts to accept config uploaded from my PC, so in conversation with RT, it was suggested to check my firmware and possibly update. As I was on 9.3.0 and the latest was 9.3.4 (with switching backlight), I made the foolish mistake of at...

I've just joined the forum, having recently purchased a Dash2 & RT CAN OBD interface for my Ultima Can AM build. I'm using an LS3 crate motor, with the full GM E67 ECU & wiring harness. With the electrics in the car now powered up (engine not started yet), I've started to look at configuring...