Apologies, I understand now. The issue isn't with the display on the DASH2, the problem is in the configuration file for the CAN interface. It should be configured to convert the values from the ECU to degrees C before they are transmitted. If you email mhill at race-technology.com I can send you an...

When the data is handled internally it is always in Degrees C. The choice of units for displaying each parameter are selected in the LCD Data area. For each temperature variable displayed you can then select if you want to show it in Degrees C, Degrees F, or K.

Email support@race-technology.com and I will send you the DL1 MK1 reflash file.

Please note that the DL1 MK1 has been out of production for 16 years and is no longer supported.

Hello,

Please would you email us with the run file in question and we will investigate.

service@race-technology.com

Hi Jeff,

There are multiple places where the sampling rate and logging rate can be configured. Please send your DL1 config to service@race-technology.com and I'll look into it.

Lorne

Correct. "Set" and "select" are used interchangeably.

Hello Chris,

Is the ECU adapter in the loop when you attempt this operation? It should not be. D2 update via DL1 is possible only when the two devices are connected directly.

Hello Adrian,

Do you have the "advanced options" licence on your DASH2 PRO? What is the serial number of your dash?

You can email me directly if you wish and I'll help you resolve.

lorne@race-technology.com

The equation you have selected is for the Race Technology supplied pressure sensor. You are using a different pressure sensor and this has different characteristics when compared with the Race Technology supplied pressure sensor.

What equation are you using for this sensor in the dash config?

What is the sensor output in volts at ambient pressure and full scale?

What is the make and model of sensor?

The options below just load in the PC software. They do not communicate with the dash so you can select any one.

When you have opened the software you need to click "read configuration". This will load the current settings from the dash which you can then save as your backup copy.

Which firmware version are you using on your DASH2? If you want to use V10 PC software it will only communicate with V10 firmware on the dash, so you must reflash the dash. BEWARE though - if you upgrade to V10 firmware you will have to recreate your dash configuration because older configuration fi...

Hello Bill,

https://www.race-technology.com/wiki/in ... uStructure

See menu item 6.4

With the vehicle in a flat and level stance this will zero the accel in all 3 axes.

Hello Martin,

Please send a photograph of the display with the power on to support@race-technology.com

This will reach me and I will then be able to diagnose the issue and advise on next steps.

Regards,
Lorne Winborn