DASH 2 is sold.

The DL1 is still available.

$775 shipped in the lower 48.

Erik
Reach me at 310-746-6552

I am selling both the DL1 data logger ($800) and the DASH2 ($825) The DL1 will come with the case, 1GB CF card, 256MB CF card, 12V AC power supply for use indoors, spare fuses, 12V car power adapter, spare GPS antenna, and spare sensor connectors. The DASH2 comes with the sensor inputs, a manual, an...

Have not tried it. I'm curious if it could be done. You may have to strip out the data by hand and format it...but in theory most of the channels you need could be fairly similar to other loggers.

Make sure your firmware is up to date on the DL1 or the setup.bin file will not take

I suppose it is possible, although that would mean 99 runs in a 24hr period which is quite a few. What type of runs are you recording? Is it possible to swap out cards half way through your day? If you are using auto start maybe there is something you can change to limit the number of non-critical r...

I fabbed up a bracket for the dash...velcro. Booya

Tam, I'm having a similar issue with the DASH2. I think it has something to do with the filtering on the dash settings. I believe my filter is averaging too many samples together causing the reading to respond slowly. Anyway, come to Streets of Willows with Speedventures in the next two months and w...

When I have this problem it is usually caused by not allowing enough time for the logger to lock onto several satellites. I am running behind and just hop in the car and drive. Usually those runs require me to cut out the first few seconds of data to remove. Out of 50 or so days that I've used the l...

Hm. If I goto my run menu/Programs/DL1/DL1 Configuration I get the configuration program for the DL1. This is the program that writes the SETUP.BIN file to the CF card. Lets try the manual config file edit approach. Were you able to find out where the file is located? I looked through the RT softwar...

Could you detail the steps to do that Graham?

I saw that there is a <BIKE> option you can add to the program command line but I didn't see any changes in the software. I suppose I could have missed them easily enough.

How does one put the logger in bike mode?

iirc the dl1 reads the file each time it starts up....and retains the file information until it reads the file again.

I just leave it on the card since I use multiple cards, until i hear a reason to take it off I guess I'll continue doing so.

Open up the values table, you may need to "customize" the values table to display the data you desire though.

You just need the weight of the car afaik.

Very simple. Pull up a graph and chart horsepower