Search found 7 matches

by DIGGIDY
Wed Jun 01, 2022 12:43 pm
Forum: General support questions
Topic: FIRMWARE: DL1 Mk2 & Dash3Pro
Replies: 4
Views: 23727

Re: FIRMWARE: DL1 Mk2 & Dash3Pro

I would imagine the firmware is part of the the old legacy software (v8.5), the download is at the bottom of the linked page below https://www.race-technology.com/gb/racing/software-downloads Information on reflashing is here https://www.race-technology.com/wiki/index.php/Reflashing/ReflashingDataLo...
by DIGGIDY
Wed Apr 06, 2022 4:28 pm
Forum: General software support
Topic: DASH-2Pro Can-bus to Haltech
Replies: 2
Views: 8633

Re: DASH-2Pro Can-bus to Haltech

I see no reason why that shouldn't work, the Dash2 Pro has 2 CAN ports available for use, and there are references to the Haltech ECU's via CAN in the knowledge base, either by using a ECU interface or the by direct CAN through the H/L wires, both require a purchase of some kind, whether that is the...
by DIGGIDY
Wed Apr 06, 2022 4:05 pm
Forum: Sensor-related questions
Topic: oil pressure incorrect reading please help
Replies: 11
Views: 60693

Re: oil pressure incorrect reading please help

What other problems are you having, not sure I can help much, but happy to give it a go ? I've was in the same situation for weeks trying to figure stuff out, and Support from RT is not very forthcoming at the best of times I'm afraid, even direct support is slow, so if you want an answer be prepare...
by DIGGIDY
Tue Apr 05, 2022 11:48 am
Forum: Installation questions
Topic: DL1 Club auto record GoPro and charging issue
Replies: 0
Views: 117107

DL1 Club auto record GoPro and charging issue

Hi, I've wired up and configured my DL1 Club to auto record my GoPro Hero 3 (using one button mod) through a wired cable to the 30 pin BUS connector, this by itself works perfectly when the logging is enabled by the external remote button I also configured. Whilst I was making the cable I also wired...
by DIGGIDY
Thu Mar 31, 2022 3:50 pm
Forum: Sensor-related questions
Topic: oil pressure incorrect reading please help
Replies: 11
Views: 60693

Re: oil pressure incorrect reading please help

You need a calibration map to setup the sensor, ideally you would get that from the sensor manufacture, but I can't see one anywhere for that sensor. You can map them yourself with a handheld pressure tester, but that extra expense for a single use? meh! Just as well purchase a new sensor with a pub...
by DIGGIDY
Thu Mar 24, 2022 10:56 am
Forum: Sensor-related questions
Topic: Oil pressure in psi, water temp sensor with single wire
Replies: 5
Views: 29356

Re: Oil pressure in psi, water temp sensor with single wire

I think this thread from another forum will help you understand it better, you have to create a calibration map for the sensor readings at various temperatures recoding the ohms, you can then translate that along with you reference voltage and pull-up into the correct voltage values using the volts ...

Go to advanced search