Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

TestConfigurationMessages / 1RTCFGTest

RT_CFG_Test: Triggered Test Configuration

RT_CFG_Test: 159, 0 (0x9F0020 + unit ID) (0x7C0)

Byte 0: Triggered testing enabled flag
Byte 1: Enable additional start condition flag
Byte 2: Enable additional end condition flag
Byte 3: Triggered test flags
Byte 4: Units to display results
Byte 5: Interval flags
Byte 6: Info at interval flags
Byte 7: Unused

Triggered testing enabled flag:

0 = disabled
1 = enabled

Start / end addition condition flags:

0 = No additional condition
Non-zero = Additional condition enabled

Triggered test flags:

Bit 0: Enable analog output (Set bit to 1 to enable)
Bit 1: Enable pulse output (Set bit to 1 to enable)
Bit 2: Reserved (Obsolete)
Bit 3: Reserved (Obsolete)
Bits 4->7: Unused

Units to display results:

Bits 0->3: Speed Units
0 => m/s
1 => kph
2 => mph
3 => knots
Remaining values unused
Bits 4->5: Distance units
0 => m
1 => ft
Remaining values unused
Bits 6->7: Accel units
0 => g
1 => m/s/s
Remaining values unused

Interval flags:

Bit 0 set: Output at regular speed intervals
Bit 1 set: Output at regular distance intervals
Bit 2 set: TBC
Bit 3 set: Reserved (not used in CAN spec)
Bits 4->7: Unused

Info at interval flags:

Bit 0 set: Output time into test
Bit 1 set: Output deviation distance
Bit 2 set: Output Acceleration
Bits 3->7: Currently unused, reserved for further possible output variables.
Page last modified on May 03, 2018, at 12:38 PM