Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

HowDoI / ControlSerialPortData

How do I control what information comes out the DL1 serial input?

step 1: Enter the DL1 configuration software. In the bottom, right hand corner of the window, you will see the miscellaneous section. Here, you will find a drop down menu displaying the serial port baud rate. You may select the baud rate that you desire from this menu.

 In the left hand side of the screen you will find a table displaying the sampling rates of each of the analogue channels.

Clicking on the channels will allow you to specify the sampling rate. It must be noted, however, that as the sampling rate increases, so too does the minimum baud rate required.

Page last modified on September 10, 2007, at 03:47 PM