Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

HowDoI / ConnectCANOutput

Connect to CAN output on Analog8

The CAN connection on Analog8 is available on the Serial Data in connection, This connection can be used to connect any 3rd party hardware capable of reading CAN.

To connect to this, the mating 9pin female Dtype connector is needed.

Connections

  • Connect CAN High from the CAN device to Pin 8 of the Serial Data in connection of Analog8
  • Connect CAN Low from the CAN device to Pin 1 of the Serial Data in connection of Analog8

Termination

Termination of the CAN lines is not provided on Analog8. Ensure that a 120ohm termination resistor is connected in parallel between CAN High and CAN Low, if the CAN device being used requires this.

Page last modified on June 18, 2019, at 04:01 PM