I have started the installation of the dash2 with can adapter bought last month i have been having problems configuring the bought MBE can adapter to the 9a4ecu i have tried continuity to the can low and high that i have soldered that are ok have tried the continuity ti the terminator plug 12v and ground wire tried your racetechnology live software and no data received at all
The data stream is set in the ecu attached are the photos
Can you please help us with this situation as we are stuck thanks Karl
Sorry cannot send attachments as telling me file is too big have emailed to support
PROBLEMS CONFIGURING DASH2 TO CAN MBE 9A4
Re: PROBLEMS CONFIGURING DASH2 TO CAN MBE 9A4
Hi Karl
We have received your emails, thank you.
Somebody from our technical support team will be in touch to assist you as soon as they can.
Best regards,
Adele
We have received your emails, thank you.
Somebody from our technical support team will be in touch to assist you as soon as they can.
Best regards,
Adele
Re: PROBLEMS CONFIGURING DASH2 TO CAN MBE 9A4
Thanks Adele
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 22 guests