Hey,
Could someone please let me know what im doing wrong? Iv wired up a extra button to analogue input 2 to tell the dash to being datalogging but when I press it nothing happens . I have wired the button as shown in the attached picture and I have also included some screenshots of how the dash is configured. Iv also had analogue 2 displayed on the dash to ensure I have wired it correctly, and when I push the button I see 13V (battery voltage) displayed on the appropriate data area
Datalog start/stop Dash2Pro
Datalog start/stop Dash2Pro
- Attachments
-
- Switch wiring.png (2.95 KiB) Viewed 11123 times
Re: Datalog start/stop Dash2Pro
Hi there,
Please ensure that "Logging Status" is set to internal source in the variable source menu of the configuration software. You can find this at the bottom of the list in Misc.
If this is ok, please drop me an email with your configuration file attached.
sam@race-technology.com
Kind Regards,
RT Support (SK)
Please ensure that "Logging Status" is set to internal source in the variable source menu of the configuration software. You can find this at the bottom of the list in Misc.
If this is ok, please drop me an email with your configuration file attached.
sam@race-technology.com
Kind Regards,
RT Support (SK)
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 10 guests