Converting .ccf CAN files for use with Dash2 Pro
-
- Posts: 110
- Joined: Wed Jul 04, 2007 11:33 pm
- Location: Toronto, Canada
- Contact:
Converting .ccf CAN files for use with Dash2 Pro
Is it possible to convert an older .ccf config file for the standalone CAN adapter for use with the new Dasd2 Pro embedded CAN interface? Or do I need to retype everything?
Peter Carroll, Toronto, Canada
DL1 and Dash2 - http://DriversMeeting.com/pcarroll
DL1 and Dash2 - http://DriversMeeting.com/pcarroll
Support
Unfortunately it is not possible to load in the .CCF into the DASH2 pro and you will need to rewrite the configuration. If it is for a standard ECU i may have already done it and happy to send you the configuration.
because the new DASH2 pro has more features in the CAN configuration then CAN adapter is the reason we didn't make it possible.
Kind regards,
Support (K)
because the new DASH2 pro has more features in the CAN configuration then CAN adapter is the reason we didn't make it possible.
Kind regards,
Support (K)
-
- Posts: 110
- Joined: Wed Jul 04, 2007 11:33 pm
- Location: Toronto, Canada
- Contact:
If you have CAN config data for DTA S100, then please send it along.
peter dot carroll at bluefriday dot ca
Thanks
peter dot carroll at bluefriday dot ca
Thanks
Peter Carroll, Toronto, Canada
DL1 and Dash2 - http://DriversMeeting.com/pcarroll
DL1 and Dash2 - http://DriversMeeting.com/pcarroll
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 11 guests