I'm using analog input #4 on a DASH 2 to read fuel level. I want to have a low-fuel warning at 2 gallons, so the low alarm was set to "2". The configuration file was then saved, and then that same configuration file was immediately reloaded and surprise, the low alarm setting of "2" had become the high alarm setting, and the low alarm value had changed to zero.
I know that the configuration file was saved because I could see that the time stamp had updated. If the alarm values had gone back to zero, that would be one thing, yet the low alarm value moved over to the high alarm field, so something fishy is going on.
A search on this anomaly turned up nothing. The Knowledge Base says nothing about the software disallowing certain values or modifying which field they appear in.
Support?
Alarm parameters changing themselves?
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 11 guests