Page 1 of 1

Problem with Lap and Sector markers

Posted: Wed Aug 02, 2017 4:43 pm
by rbahr
Hi All,

I load up a .run file and the Analysis tool loads it, automatically creates a lap marker and then a large number of sector markers. These are numbered something like M2, M2.1, M2.2, M3,... and there seem to be many. In addition, I do not see a reasonable number of sector columns

I would have expected to see a set of markers that apply to all laps and I can evaluate the laps easily.

What am I doing wrong?

Thanks

Ray

Re: Problem with Lap and Sector markers

Posted: Wed Aug 02, 2017 5:57 pm
by 924RACR
Have you perhaps selected the option selected to automatically add lap and sector markers?

I'm trying to remember where exactly the option is, maybe under Analysis options...

Re: Problem with Lap and Sector markers

Posted: Wed Aug 02, 2017 6:25 pm
by rbahr
Ok, If I deselect that, I should be able to manually enter what I want?

Re: Problem with Lap and Sector markers

Posted: Fri Aug 04, 2017 12:23 pm
by 924RACR
I believe so, give it a try... pretty sure that's how mine's set, and I do all mine manually...