Hi,
Today I connected my Dash 2 to the power for the first time using the red and black wires of the lower of the two connectors. I managed to upload a config but now I cannot make any changes the buttons do not seem to have any effect. I tried connecting to the power using the upper connector red and black wires but these do not even power up the system, anyone any ideas?
Simon
Ps been using the DL1 for a season now and it's a fantastic piece of kit!
Dash 2
Hi,
There is a display on the screen but it does nor seem to respond to inputs
I sent a mail to the address on the web site yesterday, got an auto resonse saying that This was no longer a valid way to contact support and that I needed to log a ticket on the web, which I did yesterday...no response yet.....
There is a display on the screen but it does nor seem to respond to inputs
I sent a mail to the address on the web site yesterday, got an auto resonse saying that This was no longer a valid way to contact support and that I needed to log a ticket on the web, which I did yesterday...no response yet.....
OK - that system just changed but I believe it is working. There will be a bit of a backlog due to the holidays but if you don't hear anything soon feel free to email me at ussales@race-technology.com
BTW, what country are you in?
BTW, what country are you in?
Al Seim
Race Technology USA
Race Technology USA
Dash 2 RPM
SO I'm getting closer to getting it fully working. Got all the sensors reading correctly and all the settings on the dash OK. THe Data logger is logging the data correctly as well.
LAst problem is the RPM. I cannot seem to get this sorted. I'v got a screened cable running to the data logger from the tacho feed on the car (Radical Prosport). I've tried it on the Spark and the 5v input but the RPM is allover the place on the Dash. Ive tried the filtering settings on the dash config but I cannot seem to get them right, either get no reading or the RPM climbs steadily to the max. Has anyone any ideas....
The new monitor SW would be really usefull now as every change means a reload of the Dat file
Simon
www.tillingmotorsport.com
LAst problem is the RPM. I cannot seem to get this sorted. I'v got a screened cable running to the data logger from the tacho feed on the car (Radical Prosport). I've tried it on the Spark and the 5v input but the RPM is allover the place on the Dash. Ive tried the filtering settings on the dash config but I cannot seem to get them right, either get no reading or the RPM climbs steadily to the max. Has anyone any ideas....
The new monitor SW would be really usefull now as every change means a reload of the Dat file
Simon
www.tillingmotorsport.com
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 9 guests