Page 1 of 1

Dash 2 / DL1 Sport Omex ECU Interface

Posted: Sun Mar 18, 2018 8:39 pm
by mark-one
Hello, Im trying (& failing!) to get my Dash 2 and DL1 Sport to read from my Omex 600 ECU

Im using the interface cable. connected up as per diagrams. The ECU Telemetry is set as it should be

Dash 2 is all set-up to for Omex using latest configuration software

Both devises have been re=flashed and are on current firmware

i Know the DL1 & Dash are communicating as the analogue inputs I've set up all work fine

i read on one of the knowledge base articles that i need to set the DL1 to decode the serial outputs. That's where i get stuck, as there doesn't seem to be any option to do this on the DL1 Sport configuration software

Am i missing something? Any help appreachiated

Many thanks Mark

Re: Dash 2 / DL1 Sport Omex ECU Interface

Posted: Mon Mar 19, 2018 9:55 am
by racetec
On the DL1 SPORT the only configuration required is to tick the box to say that the RPM data should be taken from the ECU interface. If that is ticked then I suggest checking the RS232 data output from the DL1 using the Live Monitor so you can see exactly what is being transmitted.

Re: Dash 2 / DL1 Sport Omex ECU Interface

Posted: Tue Mar 20, 2018 8:13 am
by mark-one
Thanks for the reply, didn't have long to check things last night. i tried what you suggested and still no joy. I will test with live monitor this evening.
One thing i did notice is that in the Omex map 4000 software there is a telemetry box for the map itself. As attached screen snip. Should either of these be 'on'?

Re: Dash 2 / DL1 Sport Omex ECU Interface

Posted: Tue Mar 20, 2018 9:29 am
by racetec
I honestly don't know on that as I have never used that software. Given that there are two options I would try with one on, if it doesn't work try with the other.

Re: Dash 2 / DL1 Sport Omex ECU Interface

Posted: Tue Mar 20, 2018 1:20 pm
by mark-one
Thanks. A bit of lunch time reading & googling found me the following;-

https://www.race-technology.com/wiki/in ... X600And710

it looks like both need to be 'on' i will give it a whirl later and report back