DASH2 RPM not displaying

glen.donhardt
Posts: 5
Joined: Wed Sep 07, 2016 3:24 am
Location: Australia

DASH2 RPM not displaying

Postby glen.donhardt » Wed Mar 15, 2017 10:46 am

Hi
I am new to this forum and seeking some assistance in configuring the RPM display on a DASH2. (standalone)
The RPM signal is a clean 33-40Hz 12 volt square wave at idle.
1k pull up to +12 volts, version 9.1.7 firmware
ECU is standard Subaru WRX 2005. The motor is in a custom manx style buggy.
RPM Screen.PNG
RPM Screen.PNG (110.06 KiB) Viewed 15271 times

Attached is the configuration of the RPM setup.

I have tried with no success, adding filtering, averaging.
the only time I see the RPM scale appear is on startup for a few seconds and then it goes back to 0.

All other programing seems to work fine
Signal has been checked, and wiring checked to connector 1, pin C

glen.donhardt
Posts: 5
Joined: Wed Sep 07, 2016 3:24 am
Location: Australia

Re: DASH2 RPM not displaying

Postby glen.donhardt » Wed Mar 15, 2017 10:51 am

Sorry, I should mention the dash2 setup is:
RPM RS232 - NO
DASH2 RPM - YES

Support (D)
Posts: 74
Joined: Mon Aug 17, 2015 9:36 am

Re: DASH2 RPM not displaying

Postby Support (D) » Wed Mar 15, 2017 11:11 am

Dear Sir,

Can you tell me where you are taking the RPM signal from on the vehicle please?

Also I noticed that the firmware installed on the unit is quite old, this may be contributing to the issue you are experiencing. Follow the link below to our knowledge base, this has information on re-flashing the DASH2:

http://www.race-technology.com/wiki/ind ... nitFromAPC

Best regards,
Support(D)

glen.donhardt
Posts: 5
Joined: Wed Sep 07, 2016 3:24 am
Location: Australia

Re: DASH2 RPM not displaying

Postby glen.donhardt » Wed Mar 15, 2017 11:20 am

The RPM signal is direct to the Subaru ECU.
Connector B137 Pin 9.
This in the standard car goes direct to the dash cluster.

I will try and reflash now and report back.

Thankyou
Glen

glen.donhardt
Posts: 5
Joined: Wed Sep 07, 2016 3:24 am
Location: Australia

Re: DASH2 RPM not displaying

Postby glen.donhardt » Wed Mar 15, 2017 11:57 am

Reflashed to 9.3.4
reloaded config file
No difference in the result.

Regards
Glen

glen.donhardt
Posts: 5
Joined: Wed Sep 07, 2016 3:24 am
Location: Australia

Re: DASH2 RPM not displaying

Postby glen.donhardt » Thu Mar 16, 2017 11:31 am

Problem resolved.

The ECU signal was not being pulled fully to ground. dropped to approx 2 volts.
Removing the 1k pull up resistor to +12 volts fixed the issue.
I tried a 5k pull up, it also failed.

Thanks for your assistance.
Glen


Return to “General software support”

Who is online

Users browsing this forum: No registered users and 4 guests