DTA E48 with DASH 2

burr_2000
Posts: 2
Joined: Tue Mar 01, 2016 2:28 pm

DTA E48 with DASH 2

Postby burr_2000 » Tue Mar 01, 2016 2:55 pm

Hi has anyone managed to get the dash 2 working with the DTA E48. i have set up the data stream as per the RT guide and connected the dash 2 to the ECU correctly as per the instructions but it does not seem to output any of the ECU channels. i am specifically looking for water temp so i set it up using V8.5 of the software and selected the correct ECU channel from the drop down. am i missing something out as both ECU and dash 2 are being powered correctly and both work fine independently so i thought it would be a simple case of connecting them together once everything had been set up. i am getting all the correct voltages and all the serial cables have good continuity. any help would be appreciated.

Support (D)
Posts: 74
Joined: Mon Aug 17, 2015 9:36 am

Re: DTA E48 with DASH 2

Postby Support (D) » Thu Jul 21, 2016 1:24 pm

Hello,

Okay so if it's possible can you send the confg file that is loaded onto the dash currently and the map file currently loaded on the ECU to my email:

daniel@race-technology.com

I can take a look at them and double check everything is set up correctly for communication.

Kind regards,
Support (D)


Return to “Installation problems”

Who is online

Users browsing this forum: No registered users and 2 guests