3 posts • Page 1 of 1
I have a s60 and dash 2 pro. I have wired the ecu and dash together using the can wires and have the can pack installed on the dash 2.i have the can function switched on in the Ecu options. When I switch ignition on and check the Dta software the ecu is displaying 12 volts but the dash is displaying to 0 volts. The can light is displayed in the dash 2 display but I don't think it's working if it's not reading voltage but the ecu is . I cannot start my engine as yet due to no manifold on it but I would like this all working before hand . At help would be greatly appreciated as if run out of things to try ....
Who is online
Users browsing this forum: No registered users and 1 guest