Noisy signals

Buckie
Posts: 23
Joined: Wed Dec 10, 2014 12:36 pm

Noisy signals

Postby Buckie » Wed Apr 29, 2015 10:07 am

Hi All,

Im experiencing a lot of noise on most sensors.
Im really out of clues how to fix this.
All cables are shielded and grounded.
DL1 is grounded.

Screen:

Image

Link to run file:

http://www.filedropper.com/sessie5


I think my rear suspension sensor = dead.

Hope someone can help me out..
Last edited by Buckie on Wed Apr 29, 2015 2:08 pm, edited 1 time in total.

Hustler
Posts: 20
Joined: Fri Jan 23, 2015 10:31 am
Location: Hamburg

Postby Hustler » Wed Apr 29, 2015 1:10 pm

settings:
Maximum rate of change/Smoothing filter time
DL1-MK3+20HzGPS, DASH3

Buckie
Posts: 23
Joined: Wed Dec 10, 2014 12:36 pm

Postby Buckie » Wed Apr 29, 2015 2:07 pm

Hustler wrote:settings:
Maximum rate of change/Smoothing filter time


Yeah ive tested that settings but then im also filtering data out..
There must be something wrong.. But I don't know where.

I you look for example at the brake sensor its giving 0,6V in "idle".

Bikey
Posts: 102
Joined: Fri Apr 29, 2011 6:05 am

Postby Bikey » Wed Apr 29, 2015 4:18 pm

Most brake pressure sensors that I have seen are ratiometric, with an output from .5v to 4.5v. So .6v at rest isn't crazy, and they are a little noisy given the large range that they cover.

You are powering all of these with the DL1 5v output?

What is your grounding setup?

Buckie
Posts: 23
Joined: Wed Dec 10, 2014 12:36 pm

Postby Buckie » Thu Apr 30, 2015 1:32 pm

Bikey wrote:Most brake pressure sensors that I have seen are ratiometric, with an output from .5v to 4.5v. So .6v at rest isn't crazy, and they are a little noisy given the large range that they cover.

You are powering all of these with the DL1 5v output?

What is your grounding setup?


Yes i'm powering all sensors with the DL1 5v output.

All sensors are directly grounded to the DL1 and the DL1 to the chassis.

Only the output from YEC loom ( TPS,Water,Speed,RPM ) are arranged by the bike manufacturer it self..

osborni
Posts: 497
Joined: Fri Dec 07, 2007 9:08 pm
Location: USA, Michigan

Postby osborni » Tue May 12, 2015 3:59 pm

That sort of noise is typical.

Experiment with rate of change and smoothing per Hustler. Step up the smoothing little by little until it looks OK. Rate of change, you should be able to do some basic math to figure out what is reasonable and what is not a reasonable about of rate change.
BMW 2000 M Coupe


Return to “General software support”

Who is online

Users browsing this forum: Google [Bot] and 13 guests