CAN communicatio

[tecae]

hello I tried to configure can module . CAN line is ok there is only one terminaison in the ECU . I configure the can transmitter. I can configure in the ecu the adress (0x100) and all type of CAN info required I selected intel I send the information on 2 bit but nothing is read in the logger or in the monitor ( I modified the setup on the DL1 to read the serial data). is ther something that i forgot to do? it is possible to "read" like with an oscillo to see if something is receive by the module. do I have to add a resitor. on the assy there DL1 mk1, dash 4 pro, CAN module and ECU (Fh electronics).

Best regards

Matthieu

[Support]

Hello,

Please can you email me the CAN protocol information for the ECU and the CAN module configuration file. kieran@race...

BR,
K