Logging DTA Analogue 2 and 3 output
Posted: Thu Jun 07, 2012 9:42 pm
I have 2 Stack Lambda gauges which output 0-5v lean / rich and have connected these to analogue 2 and 3 on my DTA S80 pro ECU.
I cannot get the logger to log these channels ....problem is I am not sure if I have the setup wrong in the DTA or DL1 !
Using the DTA monitor software I can see the channels are being logged and the values are in mV.
I have data being passed down the serial cable, but cannot see this data on the DL1.
Can anyone assist....
Cheers Simon
I cannot get the logger to log these channels ....problem is I am not sure if I have the setup wrong in the DTA or DL1 !
Using the DTA monitor software I can see the channels are being logged and the values are in mV.
I have data being passed down the serial cable, but cannot see this data on the DL1.
Can anyone assist....
Cheers Simon