Logging DTA Analogue 2 and 3 output

Espritv8man
Posts: 5
Joined: Sat May 12, 2012 9:42 pm
Contact:

Logging DTA Analogue 2 and 3 output

Postby Espritv8man » Thu Jun 07, 2012 9:42 pm

I have 2 Stack Lambda gauges which output 0-5v lean / rich and have connected these to analogue 2 and 3 on my DTA S80 pro ECU.
I cannot get the logger to log these channels ....problem is I am not sure if I have the setup wrong in the DTA or DL1 ! :?
Using the DTA monitor software I can see the channels are being logged and the values are in mV.
I have data being passed down the serial cable, but cannot see this data on the DL1.

Can anyone assist....

Cheers Simon

Rob Stevens
Posts: 36
Joined: Sun Oct 31, 2010 9:36 am

Postby Rob Stevens » Mon Jun 11, 2012 7:47 am

I use a P8 and DL1 via RT serial interface, you will find that RT call Ana 1 something else like oil pressure and Ana 2 oil temp or something, works fine on my setup, but you should have you wideband on Ana3 that way dta can use the wideband also, P8 can only take 1v on its lambda input. But watch out that RT will now give you lambda from ana3 and the proper lambda channel, plus the other ana wide band one.


Return to “Installation problems”

Who is online

Users browsing this forum: No registered users and 2 guests