So I installed the new analysis software, then loaded in a saved variables file - which of course over wrote the simulated lap variables. So now I can't do the very thing that caused me to install the updated software.... grrrrr.
So I uninstalled the software and started all over again. But my variables file is pretty complex. I'd really really dislike having to re-enter all the same data. Is there a fast way to load in my old variables and not over write the simulation part?
OK, I'm an idiot
OK, I'm an idiot
BMW 2000 M Coupe
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 11 guests