Log Status not working on new unit
-
- Posts: 5
- Joined: Mon May 15, 2006 1:59 am
Log Status not working on new unit
I have a new DL1 and all appears fine except the status logging light. When logging is occurring, the status light output holds steady at 7.8 mV with nothing connected. Thus it will not drive an LED. I have an LED for use as this status light and when connected to the 12 V supply it turns on and draws 15.5 mV. I assume I have a "bad unit." Any ideas? Will the unit need to be returned?
Thanks,
Gary
Gary
-
- Posts: 34
- Joined: Sun Nov 20, 2005 6:21 am
-
- Posts: 5
- Joined: Mon May 15, 2006 1:59 am
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 8 guests