DL1 Autostarts after Power Up

[marck_c]

Hi,

I have a DL1 and whenever it is powered up it autostarts logging after ~25 seconds. This is without pushing the log button on the front. The log button can be used to stop and start logging. However if left unattended it will automatically start logging after 25 seconds.

Note, there is no external logging switch wire connected. In fact the only wires connected to the logger are power and ground! Can anyone suggest a remedy for this?

[Support]

First thing to check is whether the Autostart function is disabled, this is done in the DL1 configuration software. Make sure this is off, if you still have the same issue let us know so we can have a closer look.

[marck_c]

Thanks. I wiped the CF card and re-did it with the Config Utility. All works fine now