Some of my files are on ver 6 and when i try to load it says old format,can not continue!
You must have a fix for that?
How can I use old run files off my laptop on version 7.2.49
-
- Posts: 220
- Joined: Thu Mar 15, 2007 3:41 pm
- Location: Norwich, UK
- Contact:
You have to load the .run files (which don't know what software you had when you made them). .raf files are version dependent, and I've not heard of a fix.
Make up a nice set of V7 layouts, variables and car parameters, and load the run files again as requiring. It doesn't take long unless you have a VAST amount of rafs (in which case only convert the ones you need at the time).
Make up a nice set of V7 layouts, variables and car parameters, and load the run files again as requiring. It doesn't take long unless you have a VAST amount of rafs (in which case only convert the ones you need at the time).
Monoposto 2000 - Reynard 883 Toyota
It is good practice to save all data in its most primitive form. I'm usually in no hurry to delete stuff from the card, because there is plenty of room.
After I download and check that data is good, I try to save raw data to the hard drive. When the card is getting a bit cluttered, I copy the whole thing, to both laptop and home desktop.
Going racing costs heaps, so that data is valuable!
After I download and check that data is good, I try to save raw data to the hard drive. When the card is getting a bit cluttered, I copy the whole thing, to both laptop and home desktop.
Going racing costs heaps, so that data is valuable!
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 9 guests