I bought a couple of pots today, 10Kohms. Wired them up to the DL1 from the 5v output, through the whole range I can't get anything else then 4.7v to 5v on any of the pots.
Measured with a multimeter the pots read from 0 to 10Kohm no problems.
What gives? Need more resistance to get the voltage down? How do I do that? Newbie to these kind of things.
Does it really matter or can I use that anyway and just adjust the scale?
On the other hand, where are all the specs on the DL1 unit? I read different things on different pages on even Race Technologys own site. Is the GPS 5 or 10Hz? Are there 4 5v inputs and 4 12v inputs or are they all 12v or are there actually only 7 analog inputs even though there are 8 terminals on the back? Which ones are 5v in that case?
I know the unit is lowish priced but hey, how about getting the specs correct and some documentation and instruction on paper, I hate help-files since thay always link in circles...
I got a new unit btw, single black connector at the rear and the serial is on the rear too.
sensor voltage weirdness..
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 105 guests