Dash 2 is great but little problem with display
Posted: Sun Apr 24, 2011 8:10 am
Really like the Dash 2 but im having a small problem with the fuel pressure display. All the sensors are RT supplied.
Im using the 4 analouge outputs
Water temp
Fuel Gauge
Oil Pressure
Fuel Pressure
The fuel pressure is showing 50 psi (correct) but drops to 9 psi and the alarm which was set at 40 psi starts flashing. I swapped the sensor and its still the same, then i changed the alarm to zero and it still displays the alarm the only difference is that the pressure changes from 50 psi to 4 psi.
To check the pressure i fitted a mechanical gauge and it sits at 50 psi without a flicker.
I would really like to get this sorted as its a great piece of kit, ive also looked at the help menu to see if i can just switch it off but my Dash 2 config doesnt have a second box to choose "Leave Blank". Not the ideal way to solve it but its better than flashing lights mid stage.
Any ideas?
Thanks
Im using the 4 analouge outputs
Water temp
Fuel Gauge
Oil Pressure
Fuel Pressure
The fuel pressure is showing 50 psi (correct) but drops to 9 psi and the alarm which was set at 40 psi starts flashing. I swapped the sensor and its still the same, then i changed the alarm to zero and it still displays the alarm the only difference is that the pressure changes from 50 psi to 4 psi.
To check the pressure i fitted a mechanical gauge and it sits at 50 psi without a flicker.
I would really like to get this sorted as its a great piece of kit, ive also looked at the help menu to see if i can just switch it off but my Dash 2 config doesnt have a second box to choose "Leave Blank". Not the ideal way to solve it but its better than flashing lights mid stage.
Any ideas?
Thanks