Page 1 of 1
ECU interface wiring
Posted: Wed Nov 05, 2014 2:18 pm
by blentz2
I want to cut out and replace the db9 connectors for my installation. Is there anything special about the wire that I need to be aware of? Is it shielded or anything? This is for an autronic ECU.
Posted: Fri Nov 07, 2014 4:18 pm
by blentz2
Hello, anyone from race tech there to answer my question?
Posted: Tue Nov 11, 2014 1:05 pm
by Support
Hi there,
No, there is nothing special about the cabling used on the ECU interface. Aslong as the correct connections are made you should have no problems.
I must advise that removing the DB9 connector will void the warranty on the ECU interface and so I would recommend testing functionality of the unit prior to dissasembly.
Kind Regards,
Support (SK)