Newbie Questions
Posted: Wed Dec 18, 2013 10:57 am
Hi
I have spent hours going through the forum but I would really appreciate a couple of answers:-
1) I have an Edis based ignition set up and currently use the edis to coil pack signal for my STACK tacho input. According to my multimeter it is 12v. Can I use this with DASH2?
2) Do I share the 5v reference with speed, temp and pressure sensors?
3) Do I need to connect both +ve and grounds for Connector 1 & 2?
Sorry these are a bit basic.
Chris
I have spent hours going through the forum but I would really appreciate a couple of answers:-
1) I have an Edis based ignition set up and currently use the edis to coil pack signal for my STACK tacho input. According to my multimeter it is 12v. Can I use this with DASH2?
2) Do I share the 5v reference with speed, temp and pressure sensors?
3) Do I need to connect both +ve and grounds for Connector 1 & 2?
Sorry these are a bit basic.
Chris