DL1/Dash 2 RPM questions
Posted: Tue Nov 19, 2013 9:17 am
Hi All,
I have a standard electronic distributor type ignition.
I have connected the -ve coil to the rH input on the DL1 and the rG to the body. Without the engine running I get over 7000 rpm. This only happens when I connect the ground, otherwise I get nothing, engine running or not.
This is a brand new DL1 Mk2, the Dash 2 is a few years old.
Anyine have any ideas what I have done wrong? I'm hesitant to connect the -ve coil up to the rL, though that has worked in the past, but I get strange signals. This is why I have a new DL1 BTW, the old one is being repaired, though there wasn't anything wrong with the rL circuit.
Cheers
Stu
I have a standard electronic distributor type ignition.
I have connected the -ve coil to the rH input on the DL1 and the rG to the body. Without the engine running I get over 7000 rpm. This only happens when I connect the ground, otherwise I get nothing, engine running or not.
This is a brand new DL1 Mk2, the Dash 2 is a few years old.
Anyine have any ideas what I have done wrong? I'm hesitant to connect the -ve coil up to the rL, though that has worked in the past, but I get strange signals. This is why I have a new DL1 BTW, the old one is being repaired, though there wasn't anything wrong with the rL circuit.
Cheers
Stu