RPM on a coil and distributor setup
Posted: Wed Feb 29, 2012 9:57 pm
Hi again,
Another question that i couldn't quite find the answer to in the knowledge base and due to the "incorrect connection could damage your DL1" i thought i better ask to confirm.
the vehicle i'm installing the DL1 onto runs a simple distributor setup which currently has the normal tacho output on the negative side which goes to a standard style tacho.
Where would i connect the DL1 into my system?
The knowledge base says I should connect this in but doesnt really say where - Hi (rH) or low (rL) level connection on the DL1?
Is it simply a direct wire or do I need some sort of pickup box?
Do I need to connect a ground wire in anywhere?
I'm a bit lost on this, the knowledge base contains so much information its easy to get overwhelmed![/code]
Another question that i couldn't quite find the answer to in the knowledge base and due to the "incorrect connection could damage your DL1" i thought i better ask to confirm.
the vehicle i'm installing the DL1 onto runs a simple distributor setup which currently has the normal tacho output on the negative side which goes to a standard style tacho.
Where would i connect the DL1 into my system?
The knowledge base says I should connect this in but doesnt really say where - Hi (rH) or low (rL) level connection on the DL1?
Is it simply a direct wire or do I need some sort of pickup box?
Do I need to connect a ground wire in anywhere?
I'm a bit lost on this, the knowledge base contains so much information its easy to get overwhelmed![/code]