Dash2 RPM on YB Cosworth Engine

TrackBuster
Posts: 5
Joined: Thu Oct 28, 2010 2:45 pm

Dash2 RPM on YB Cosworth Engine

Postby TrackBuster » Tue Jun 07, 2011 3:43 pm

hi, can somebody give me a tip where i can conect my rpm signal to my engine wiring? i´m a electric noob :oops:

Image

Image

TrackBuster
Posts: 5
Joined: Thu Oct 28, 2010 2:45 pm

Postby TrackBuster » Thu Jun 09, 2011 9:10 pm

nobody?

Rob Stevens
Posts: 36
Joined: Sun Oct 31, 2010 9:36 am

Postby Rob Stevens » Fri Jun 10, 2011 7:21 am

To the wire that says to taco in grid A7

TrackBuster
Posts: 5
Joined: Thu Oct 28, 2010 2:45 pm

Postby TrackBuster » Fri Jun 10, 2011 1:09 pm

Rob Stevens wrote:To the wire that says to taco in grid A7


hm, but is it ok that this one comes from the ignition coil (minus)?

cheers
yogi

Rob Stevens
Posts: 36
Joined: Sun Oct 31, 2010 9:36 am

Postby Rob Stevens » Fri Jun 10, 2011 1:23 pm

will be fine, it will go 0v 12v 0v 12v 0v as the engine runs, dl1 will love it

TrackBuster
Posts: 5
Joined: Thu Oct 28, 2010 2:45 pm

Postby TrackBuster » Wed Jun 15, 2011 8:17 pm

ok, thanks. but i dont have a dl1, i have a dash 2.

cheers
yogi


Return to “Installation questions”

Who is online

Users browsing this forum: No registered users and 40 guests