Hello,
I'm using a Dash3, DL1 and Video4 equipment.
From time to time I want to change screens on my Dash 3 but it often refuses to accept the DASH.HEX file.
I stuck the CF card into the video4 slot, then after about 10 seconds the Dash screen shut its background light off and in most cases a "Race Technology" screen appears.
Then after a few minutes the light on the screen is switched on again but there are no changes to the config and the DASH.HEX hasn't been moved to the "Done" folder.
What can I do to make the updating more consistent?
Cheers
Chris
Dash3 configuration updating - not always possible
Okay - now it is getting complecated:
If I disconnect the video 4 and update the DASH3 over DL1 then it takes over the changes.
If I start it together with the video4 then the current config is overwritten to the old version.
If I disconnect the v4 again then the new config is read again from the CF card and the new version is present.
How does the V4 overwrite the dash3 config but it don't have a CF card installed?
Chris
If I disconnect the video 4 and update the DASH3 over DL1 then it takes over the changes.
If I start it together with the video4 then the current config is overwritten to the old version.
If I disconnect the v4 again then the new config is read again from the CF card and the new version is present.
How does the V4 overwrite the dash3 config but it don't have a CF card installed?
Chris
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 10 guests