In the knowledge base it states i should mount the DL1 buttons back, away from direction of travel, but in the analysis software it implies that i can mount it side ways or back to front, and compensate
I need to fit it sideways really as the space is tight (it's a motorcycle)
What can i do?
cheers
JP
mounting orientation of DL1
IIRC, MK2 units (large black plug) have a 3 axis sensor that allow any orientation. MK1 was 2 axis.
Jeremy Lucas
Fast Tech Limited - a Race Technology Dealer
Fast Tech Limited - a Race Technology Dealer
Note that on a bike, much of the accelerometer data can be misleading.
For mapping analysis, you should disable the accelerometers.
The GPS will do the job for you, with the DL1 mounted in any orientation.
Just make sure that it is not too close to sources of EMI.Same goes for the routing of the antenna cable.
For mapping analysis, you should disable the accelerometers.
The GPS will do the job for you, with the DL1 mounted in any orientation.
Just make sure that it is not too close to sources of EMI.Same goes for the routing of the antenna cable.
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 251 guests