Can you let us know what we need to do / get to get this all working together.
Thanks
Leigh
DL1 Dash2 and Emerald ECU.
BBWRacing wrote:I've spoken to RT, and it look like you have to plug the ECT interface into the PC lead, not direct to the unit.
Will try tonight and post my findings.
Good news its all now working.
Well if you have the DL1 and Dash2 connected to the Emerald via the Emerald PC cable.
The Dash2 is still not working standalone with the Emerald.
Also would have been handy to either put you need to use the Emerald lead in the manual or wire the correct pins in the 9 pin ECU end. (I know if they did this you would not be able to flash update via the PC with out a special converter.)
Jimster wrote:are you using the ECU interface, or going direct from emerald to the DL1?
Is this the K3 or M3dk ECU??
Cheers
Jim
It's with the RT ECU interface, but you also have to use the PC cable that you get with the EMERALD, unless you convert the RT DB9 connector to use EMERALD pin out not stand serial ones.
Also its the M3dk ECU.
Tel: 01953 889110...Fax: 01953 889004
emeraldM3D@aol.com
emeraldM3D@aol.com
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 2 guests