I have a DL1 (2 green connectors) and have only been using 2 analog sensors up to now. I have since taken an rpm feed from the ECU of my motorcycle and fed it into the rpm 5v connection.
After setting up the correct 'Ignition Pulses per Revolution' in vehicle options I was able to log rpm correctly. After only one days use I now get no data from the rpm at all.
I can still view previous rpm logged in the software so my software isn't the issue, it just looks like that channel has died?
DL1 rpm issues
If it is the same connection that goes to the primary side of the coil it may have damaged the DL1, that signal should go to "spark in".
If it is low voltage diagnostic or tach signal (say, 0-5V), it should not have hurt the DL1. I assume all connections are good?
You can always try feeding the signal into "spark in" and seeing if that works.
If it is low voltage diagnostic or tach signal (say, 0-5V), it should not have hurt the DL1. I assume all connections are good?
You can always try feeding the signal into "spark in" and seeing if that works.
Al Seim
Race Technology USA
Race Technology USA
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 273 guests