DL1 Mk2 overriding auto Start and stop logging
Posted: Sat Jun 12, 2021 1:39 pm
Does the push button start /stop logging on the front panel override the auto start stop programmed, configured on the CF card ? I use 40kph and 10kph to auto start and stop logging
I want to log Oil Pressure, Fuel Pressure, RPM and water temp while in the workshop for reference purposes - I could load the RT files off the CF card but data was complete rubbish - Log light was lit on the DL1 face as well as on my connected Dash 2 - top left green shift light
Note : DASH 2 screens shows all 5 analogue inputs via the serial cable , from DL1 and also the two Dash2 direct analogues - Oil and Fuel Pressure
I tried it by pushing the log button after starting the engine , i.e logger switched on my ignition switch - Normally used CF card was in the DL1 before it was switched on
So question is can I log data while in the workshop if my DL1 is configured for specific auto/stop logging
I want to log Oil Pressure, Fuel Pressure, RPM and water temp while in the workshop for reference purposes - I could load the RT files off the CF card but data was complete rubbish - Log light was lit on the DL1 face as well as on my connected Dash 2 - top left green shift light
Note : DASH 2 screens shows all 5 analogue inputs via the serial cable , from DL1 and also the two Dash2 direct analogues - Oil and Fuel Pressure
I tried it by pushing the log button after starting the engine , i.e logger switched on my ignition switch - Normally used CF card was in the DL1 before it was switched on
So question is can I log data while in the workshop if my DL1 is configured for specific auto/stop logging