Upgraded a customer's Dash2 to version 10 firmware.
Now i can't configure input channels on his DL1 Mk2???? Unless i'm being daft and can't find where to enter formula for sensors.
Looks like i'm going to have reinstall the old firmware.
8.5 Software and DL1 Mk2 Issue
Re: 8.5 Software and DL1 Mk2 Issue
Hello Peter
A member of our support team has contacted you by email regarding your query. Please let us know if you have not received anything from us.
Best regards,
AH
A member of our support team has contacted you by email regarding your query. Please let us know if you have not received anything from us.
Best regards,
AH
Re: 8.5 Software and DL1 Mk2 Issue
Hello Peter
A member of our support team has contacted you by email regarding your query. Please let us know if you have not received anything from us.
Best regards,
AH
Thanks.
No email received. Checked my spam and that the board has correct email address.
Re: 8.5 Software and DL1 Mk2 Issue
Hi, I would also appreciate this information
Thanks
Thanks
Re: 8.5 Software and DL1 Mk2 Issue
The DL1 MK2 can only run on and communicate with V8.5 software / firmware, so if using other products with the DL1 these must also remain on V8.5.
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
Re: 8.5 Software and DL1 Mk2 Issue
No problem with using V8,5 . Got all for my needs
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 2 guests