DL1 Club Battery Voltage

dawinschie
Posts: 10
Joined: Thu May 06, 2010 1:06 pm
Location: Aachen, Germany

DL1 Club Battery Voltage

Postby dawinschie » Wed May 18, 2016 8:52 am

Hello race-tecs,

How do you log the Battery voltage?
Connecting the PowerSupply to one of the analog channel (like I normaly do) leads to an error:

DL1 #21069: Ana 1 short to Bat

Thanks and regards

dawinschie
DL1 - VIDEO4 - DASH4

Support (D)
Posts: 74
Joined: Mon Aug 17, 2015 9:36 am

Re: DL1 Club Battery Voltage

Postby Support (D) » Wed May 18, 2016 10:00 am

Hello there,

So to log the Battery voltage on the DL1 CLUB you need to first ensure the RT software on the computer and firmware on the DL1 CLUB are both up to date.

Once this has been achieved follow the steps below:

Open the DL1 CLUB configuration software > connect the DL1 to the computer using the supplied USB lead > use the read configuration feature to read the config back from the unit > Go to variable mapping > scroll down to battery voltage at the bottom of the window > set this to be taken from units built in inputs and sensors > Select OK on the window > use the send configuration feature to send the new config to the DL1 > restart the unit and you should now be able to log the battery voltage provided of course the DL1 is powered from the battery.

Note: In the variable mapping section you may not be able to set battery voltage to come from built in inputs and sensors, if this is the case ensure that the battery voltage has been disabled in the analogue inputs / CAN input sections of the software.

Kind regards
Support (D)

dawinschie
Posts: 10
Joined: Thu May 06, 2010 1:06 pm
Location: Aachen, Germany

Re: DL1 Club Battery Voltage

Postby dawinschie » Thu May 19, 2016 8:24 am

Dear Support,

thanks. After all your hints are very helpful. But...

I am not able to flash the last firmware onto the DL1 Club. Not via USB nor Serial (the also post DL1 Club USB).

Installing the last software on the computer your installer decided (itself) for a "German" Version. The result is a horrible mismatch
with German and English fragments. A post into the software-forum will follow.

Your knowledge base are nice and helpful supplements, a manual is still missing.

Thanks and regards

dawinschie
DL1 - VIDEO4 - DASH4


Return to “General support questions”

Who is online

Users browsing this forum: Google [Bot] and 36 guests