DASH2PRO speedo stopped working in firmware 4.0.30

lewis
Posts: 3
Joined: Fri Apr 24, 2015 9:43 pm

DASH2PRO speedo stopped working in firmware 4.0.30

Postby lewis » Sat Jul 18, 2015 5:05 pm

I upgraded the DASH2PRO to the 4.0.30 firmware and to the 4.0.36 that comes with the latest 8.5 software download. Both versions completely stopped the speedo showing anything other than 0mph. I downgraded back to 3.5.x something that it shipped with and speedo works again. I use the VRS signal conditioner to convert the signal from my gearbox sender.

Any ideas what caused the speedo to stop? As far as I could tell the speedo was enabled and configured the same as before.

Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 36 guests