Is it possible to define ones own boolean variable that would be set when the engine is running, i.e. 0 when RPM < 500 and 1 when RPM >= 500 and then use that variable in controlling more than one output driver?
I could control each output driver I need with the actual RPM check as well as any other parameter (I think), but if I needed to change the RPM value used, I would need to adjust it in each output driver in which it was being used. However, if I could define a variable as above, then a single modification of that variable calculation would affect all instances of that variable in use.
Can I do this?
Variables
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 24 guests