Unable to display data on some channels from ECU in Analysis
Posted: Thu Apr 23, 2015 7:48 am
I have a DTA80 > CAN Interface > DL1 (mk2) > Dash 3
I just can't get the analysis software to decode some of the ECU transmitted data, this includes the voltage and Lanbda from the DTA, in the analysis variables it shows data is available, but when graphed its just a '0' flat line. I know both the channels are being decoded as I can display them just fine on the Dash 3.
Many of the ECU channels like water, oil, pressure etc working just fine.
Any ideas?
I just can't get the analysis software to decode some of the ECU transmitted data, this includes the voltage and Lanbda from the DTA, in the analysis variables it shows data is available, but when graphed its just a '0' flat line. I know both the channels are being decoded as I can display them just fine on the Dash 3.
Many of the ECU channels like water, oil, pressure etc working just fine.
Any ideas?