Page 1 of 1
Dash2 calibration
Posted: Mon Feb 24, 2014 10:34 am
by markk
123
Posted: Wed Feb 26, 2014 12:28 pm
by Support
It might sound obvious, but are the channels of data you want to display definitely being sent to the DASH2? You can check this by connecting the serial port which usually sends data to your DASH2 to a computer and looking at the data on the 'lite monitor' software.
Martin
Posted: Wed Feb 26, 2014 1:33 pm
by markk
no longer req.
Posted: Wed Feb 26, 2014 1:49 pm
by markk
no longer req.
Posted: Wed Feb 26, 2014 2:29 pm
by markk
Thanks Martin, easily sorted over the phone !
Regards
Mark
Posted: Wed Aug 06, 2014 9:41 pm
by markk
no longer req.
Posted: Thu Aug 07, 2014 11:15 am
by markk
no longer req.
Posted: Tue Aug 12, 2014 8:43 am
by racetec
Hi Mark,
I have forwarded the email you sent us to an engineer directly. I hope this helps.
Best regards,
Debbie.