DASH2 wont read when Flash Card inserted in DL1

marck_c
Posts: 40
Joined: Sat Sep 06, 2008 2:37 am

DASH2 wont read when Flash Card inserted in DL1

Postby marck_c » Sat Jun 25, 2011 7:58 pm

I have a DL1 along with DASH2. I have it connected to a DTAS80 Ecu through RT's Serial ECU Interface cable. My problem is, that whenever I insert the flash memory card in the DL1, I cannot read any of the ECU serial data on the DASH2 (Water Temp, Oil Temp, Fuel Press, etc). If the flash card is removed these parameters all read fine on the DASH2.

I've tried copying an identical dash.dat file to the flash card, as is on the DASH2. I've also tried leaving the Flash Card completely blank.I have also tried a completely different flash card with the above variations. To no avail.

Has anyone had a similar problem, and if so what's the fix?

Thanks


P.S. Here is an added twist. If I insert the card after I turn the DL1/DASH2 on the problem does not occur. Once I switch the DASH/DL off and restart them, I have this problem. ?????

Also none of the ECU data is logged to the card. Only the DL1 analog channels.

Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 38 guests