Haltech CAN Interface

[marck_c]

Is there any information available from Support on how to connect the DL1 to the Haltech PS1000 ECU via the CAN Interface?

[Support]

We haven't programmed an interface for this specific ECU, but if you have the relevant information about the CAN IDs used by the Haltech then its relatively easy to configure the ECU interface.
If you open up the CAN configuration software then you will see what information is needed.

[TCR]

Hi marck,

I have the relevant CAN ID information from Haltech if you need it.

I haven't looked any further into connecting my PS1000 ECU to my DL1 yet, as I have only just set it up and have yet to order an CAN cable from RT. Hopefully it won't be too hard to input the relevant information into the configuration software.

PM an email addres if you want a copy of the CAN ID info.

Paul.

[itb242]

Paul,

Have you setup your Haltech PS1000 ECU to DL1 CAN interface? I'm getting ready to purchase a DL1 and I currently have a PS1000 ECU for my car. I tried to PM you, but I keep getting a message that private messages are disabled for this forum. Please send the info to russelldb(at)hotmail(dot)com.

David