I have a DL1, Dash2 and Video4 with an ECU interface for a DTA S60, everything is working nicely except for the RPM which I cannot get to work at all. I have set everything up as it should be-main points been that RPM is disabled for storage and serial port as per the note in the configuration tool, and I get a reading, albeit not an accurate one in the Lite monitor to say that RPM is been output by the ECU interface and CAN (reads roughly half the actual rpm). I am not sure what the scalings should be in the Dash2 configuration tool when it takes its reading from the ECU interface but have tried 0,1, 10 and 100 in an attempt to get some sort of display but nothing has worked. As standard I think the DTA gives 2 pulses per rev.
I am assuming I have overlooked something, but as far as I can tell everything is as it should be.
I can't run a seperate wire for the rpm from the ecu either as I have wired it all in now and I am not taking the interior out again unless I really really have to, its not exactly easy.
Any help much appreciated.
RPM not working from ECU interface.
-
- Posts: 10
- Joined: Thu Apr 15, 2010 7:40 am
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 261 guests