Hi
I have both the above connected via the DL1 can not see any data for these 2 sensors on the analysis at all.
Have I not done something correctly?
Thanks in advance.
Logging AFR and EGT on DL1
-
- Posts: 82
- Joined: Wed Nov 29, 2006 10:36 pm
- Location: South Africa
- Contact:
-
- Posts: 82
- Joined: Wed Nov 29, 2006 10:36 pm
- Location: South Africa
- Contact:
Jacko996,
If you are getting the readings on the Dash2 then you can bring them directly into the DL1 using the (already) installed serial cable. DL1 analog inputs 17 to 20 correspond to Dash2 analog inputs 1 to 4. Just use the same formula for AFR that you used in the Dash2.
If you are getting the readings on the Dash2 then you can bring them directly into the DL1 using the (already) installed serial cable. DL1 analog inputs 17 to 20 correspond to Dash2 analog inputs 1 to 4. Just use the same formula for AFR that you used in the Dash2.
Regards,
Gary...
Johannesburg
South Africa
Gary...
Johannesburg
South Africa
GMS Racing wrote:Jacko996,
If you are getting the readings on the Dash2 then you can bring them directly into the DL1 using the (already) installed serial cable. DL1 analog inputs 17 to 20 correspond to Dash2 analog inputs 1 to 4. Just use the same formula for AFR that you used in the Dash2.
Thanks Gary. That sounds like the best way to go.
At the moment I have the AFR and EGT wired inti DL1 analog inputs 2 and 3. and get readings on the dash2 which were configured in the dash 2 software.
Do I just have to enable 18 and 19 inputs on the DL1 config? or do I have to move the sensor wires to those inputs as well?
Cheers
Dave
Unless you need more inputs for use on the DL1 there's really no need to move them. But if you do want to move them, yes, you will have to move the sensor wires to the DASH2.
I think Gary was just letting you know where they log to if you had them already going to the DASH2.
I think Gary was just letting you know where they log to if you had them already going to the DASH2.
Jeremy Lucas
Fast Tech Limited - a Race Technology Dealer
Fast Tech Limited - a Race Technology Dealer
-
- Posts: 82
- Joined: Wed Nov 29, 2006 10:36 pm
- Location: South Africa
- Contact:
jlucas,
You are right, I thought that because he was reading the correct values in the Dash2 they had been directly wired into it.
jacko996
If the Dash2 is correctly reading the AFR then all you have to do is enter the same custom formula you used in the Dash2 setup in the DL1 custom formula area for analog input 2 (it that's the one you have hard wired the AFR to.
You are right, I thought that because he was reading the correct values in the Dash2 they had been directly wired into it.
jacko996
If the Dash2 is correctly reading the AFR then all you have to do is enter the same custom formula you used in the Dash2 setup in the DL1 custom formula area for analog input 2 (it that's the one you have hard wired the AFR to.
Regards,
Gary...
Johannesburg
South Africa
Gary...
Johannesburg
South Africa
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 279 guests